![]() ![]() Kerio Control turns off after the recovery finishes.Wait for applying the kerio-control-rescue script. Plug the USB flash drive into a USB port of your Kerio Control Box.Save the kerio-control-rescue file to the USB flash drive using the following command: sudo dd if=rescue.img of=/dev/disk1 bs=1m and replace rescue.img with the real file name and /dev/diskX with the actual device name.Use the sudo diskutil unmountDisk /dev/diskX command to unmount the flash drive.Use the sudo diskutil list command to detect the USB flash drive name (for example, /dev/diskX).Run the terminal: Applications > Utilities > Terminal.Eject the USB drive safely and remove it from the USB port.Use the sync command to ensure all disk operations finish.You must type the physical device (for example, /dev/sdx), not a partition (for example, /dev/sdx1). Save the kerio-control-rescue file to the flash drive using the following command: dd if=rescue.img of=/dev/sdx bs=1M and replace rescue.img with the real file name and /dev/sdx with the actual device name.Use the command fdisk -l to detect the USB flash drive name (for example, /dev/sdx).Run the terminal (console) in the super-user mode (for example, using the suor sudo -s command depending on your Linux distribution).NOTE: All data on the flash drive will be completely overwritten. Eject the flash drive securely and remove it from your computer.In Image Writer, find the file, select your flash drive and click Write.Download the kerio-control-rescue file.Download and unpack Image Writer (it does not require installation).NOTE: All data on the flash drive is completely overwritten. Insert the flash drive into a USB port on your computer (1 GB and more).Preparing a flash drive for a complete system recoveryįor complete system recovery, you must save the installation disk image directly to the physical device. In this configuration, if a System Restore key is plugged into the front USB port, it will always work normally.WARNING: Before doing a complete system recovery, restore the default configuration, and then retest the connection to Kerio Control. Then, make sure the USB extender cable for the front panel USB ports is plugged into the USB port directly above the Waves USB license key on the motherboard. ** Any users who wish to keep the Waves USB license key stored inside the S6L Control Surface should plug the key into the bottom left USB port on the S6L motherboard (this is the port closest to the meter bridge). The Waves USB license key can be connected to the external USB ports to avoid this issue in the future, or see the note and photo below about connecting the key internally. Reconnect the Waves USB key when the System Restore is finished.Power on the control surface while holding F10 on the USB keyboard to boot normally from the System Restore USB key.Remove the S6L Control Surface rear cover.Note that this conflict only occurs when the Waves USB license key has been installed directly to certain USB ports inside the S6L Control Surface. This problem is caused by a boot device conflict that occurs when both the VENUE System Restore USB key and a Waves USB license key are connected. "The restore image on this USB drive is not valid" error or "Invalid Partition Table" error occurs or a FreeDOS screen appears when attempting to boot the S6L Control Surface from a System Restore USB drive by holding F10 at startup. "The restore image on this USB drive is not valid" error or a FreeDOS screen appears when attempting S6L System Restore ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |